Komatsu — 29.9.c CHANGING THE SWING MOTOR OIL

SCHEDULED MAINTENANCE 29.9.b CHANGING THE FINAL DRIVES OIL DANGER Lubricants, filters, coolants, and batteries are special waste products and must be disposed of in compliance with local waste disposal laws. Park the machine on firm, level ground. The machine should be hot after a day’s work so that the oil flows out readily, carrying with it all solid particles in suspension. 1 - Slowly move the machine until the drain plug (2) is located at the bottom of the hub and the level hole (1) is aligned along the horizontal line passing through the centre of the hub. 2 - Remove drain plug (2) and drain out all the old oil. Also remove filler plug (1) to help the oil flow out more easily.

Use the 8 mm wrench. 3 - When all the old oil has drained out, replace drain plug (2) and fill the axle with the recom- mended oil through filler hole (1) until oil starts to flow out of the filler hole. 1 4 - Replace filler plug (1). Drive the machine for a while, then stop and check the level again. Use only the recommended oil. (See section «26. FUEL, COOLANT, AND LUBRICANTS»). 2 F00289 29.9.c CHANGING THE SWING MOTOR OIL DANGER Lubricants, filters, coolants, and batteries are special waste products and must be disposed of in compliance with local waste disposal laws.

This operation must be performed at the end of a day’s work when the machine is still hot, so that the oil drains easily, taking with it any solid particles in suspension. The machine must be parked on firm, level ground. 1 - Remove the cab lower cover, remove drain plug (2) and drain out all the old oil. Use the 16, 17 and 19 mm wrench. Also remove level plug (1) and breather plug (3) which also serves as filler. Use the 8 and 19 mm wrench. 134