Komatsu — 29.9.d CHANGING THE GREASE IN THE FIFTH WHEEL PINION GEAR

SCHEDULED MAINTENANCE 29.9.d CHANGING THE GREASE IN THE FIFTH WHEEL PINION GEAR DANGER Lubricants, filters, coolants, and batteries are special waste products and must be disposed of in compliance with local waste disposal laws. IMPORTANT This operation must be performed with the machine parked on firm, level ground, while still hot after a day’s work. Proceed as follows: 1 - Place a suitable container under drain plug (2). Remove the filler and inspection panel (1) and the drain plug (2) to drain off the old grease. Use the 17 mm wrench. 2 - Use the suction pump provided in the tool-kit to suck out all remaining grease. 3 - Replace drain plug (2).

4 - Inject new grease of the recommended type (see section «26. FUEL, COOLANT, AND LUBRICANTS») until the grease level reaches half way up the fifth wheel teeth, i.e. a depth of about 100 mm. 5 - Replace the filler and inspection panel (1). Check the level of the grease again after about two hours work. D00048 1 1 2 100 mm F00211 136