Komatsu — 29.10.a WASHING OUT THE COOLING SYSTEM

SCHEDULED MAINTENANCE 29.10 OCCASIONAL MAINTENANCE 29.10.a WASHING OUT THE COOLING SYSTEM DANGER Take special care when performing this operation, since the engine must be left running. Have an operator stay in the driving seat and agree on all possible instruc- tions in advance. When the machine has just been stopped, the engine coolant is very hot and still under pressure, and can cause serious burns. Wait for the engine to cool to about 40 ч 45 ° C before draining the coolant. Slacken off the radiator cap slowly to release residual pressure from the tank. Make sure that all equipment safety locks are engaged, and that the working brake is engaged.

Lubricants, filters, coolants, and batteries are special waste products and must be disposed of in compliance with local waste disposal laws. Every time you switch from water to a water and anti-freeze mix or vice-versa, the cooling system must be washed out to prevent encrustations from building up. Proceed as follows: 1 - While the coolant is still warm, remove the radiator drain plug (2), the engine block drain plug (3), and the radiator filler cap (1). Use the 13 and 14 mm wrench. 2 - Drain out all the old coolant, and replace the engine block drain plug (3) and radiator drain plug (2).

3 - Add a good quality flushing product to the radiator, following the manufacturer’s instruc- tions, and top up with water. The cooling system has a total capacity of 24 litres. 2 F00214 3 F00213 139