Komatsu — 29.10.b ADJUSTING TRACK TENSION

SCHEDULED MAINTENANCE 1 4 F00212 F00855 4 - Start the engine and run it at high revs for about 15 minutes. 5 - Decelerate the engine to a fast idle and drain off the flushing mixture from the radiator drain plug (2) while refilling with clean running water for at least 40 minutes; 6 - Switch off the engine and drain off all the water from the cooling system. Replace and tighten the radiator drain plug (2) and fill the system with water or permanent coolant. 7 - Start the engine and check the level of coolant in the radiator after a few minutes. Top up if necessary. Replace filler cap (1).

8 - Wash out the expansion chamber (4) and top up with water or permanent coolant to a level between the minimum and maximum level marks. IMPORTANT If the water used to fill the cooling system is a hard water, wash the system out more frequently. 29.10.b ADJUSTING TRACK TENSION DANGER The grease in the tensioning cylinder is under pressure. Do not unscrew the greas- ing nipple (1) for more than one turn. If the greasing nipple is unscrewed fully, grease may be blown out under pressure, causing serious injury. Also, be careful not too loose any part other than the greasing nipple (1).

If it proves very difficult to pump grease into the greasing nipple, drive the track in question briefly in forward and reverse and try again. 140