Komatsu — 29.10.b ADJUSTING TRACK TENSION

SCHEDULED MAINTENANCE CHECKING TRACK TENSION Park the machine on firm, level ground and lower the equipment. Place a straight bar on top of the track with one end resting on the track idler and the other on the middle carrier roller. Measure the gap between the shoe and the bar at the point of greatest sag. The gap should be between 20 and 25 mm. If the gap is outside these tolerances, adjust track tension as necessary. 20 ч 25 mm F00292 ADJUSTING TRACK TENSION Increasing tension 1 - Remove the track tensioner cover bolts and lift off the track tensioner cover. Use the 5 mm wrench. 2 - Pump grease into the greasing nipple (1) until the correct tension is obtained.

3 - If the head of the track tensioner reaches posi- tion «S» at 25 mm, and the track is still not tight enough, the bushings and pins of the track chain are worn and must be turned around or replaced. Contact your FKI dealer whenever tracks require repair or replacement. F00290 1 Decreasing tension 1 - Remove the track tensioner cover and slowly unscrew the greasing nipple (1) to leave some grease out. Do not unscrew the greasing nip- ple more than one turn. Use the 5 and 27 mm wrench 2 - If the grease does not come out easily, drive the track in question briefly in forward and reverse. 3 - Retighten the greasing nipple and clean off excess grease from around it.

4 - Drive the machine a short distance in forward and reverse, then stop and check track ten- sion again. S D00151 141