OPERATING THE MACHINE 16.2.2 STARTING A COLD ENGINE AND STARTING IN COLD WEATHER DANGER Do not use easy start sprays or other cold start products which are ether based, since these can lead to explosions. 1 - Move the accelerator lever to fully accelerated position and turn the ignition key to posi- tion « I ». Make sure that the preheating warning light comes on. Preheating takes about 13 seconds. The warning light goes out when preheating is complete. 2 - Turn the ignition key to position « » and hold until the engine starts. Do not hold for more than 15 seconds.
3 - As soon as the engine fires, release the ignition key, which will return to position « I », and return the accelerator to idling position. F00162 D00213 IMPORTANT If the engine fails to start, repeat steps 1 and 2 as necessary, but wait at least 30 seconds between attempts to avoid straining the battery. 16.3 WARMING UP THE ENGINE 1 - Once the engine has started, allow it to warm up before you start work. 2 - Establish a fast idle with the accelerator lever until the engine is warm. 72