. MAINTENANCE SERVICE PROCEDURE BLEEDING AIR FROM HYDRAULIC CIRCUIT (PAGE 4-48)". 4 - 39 1. Check that the hydr aulic oil in the hydraulic tank is at th e specified level. 2. Run the engine at l ow idle, and extend and retract the st eering, bucket, and li ft arm cy linde rs 4 to 5 times . Be careful not to operat e the cylinder to the end of its stroke ( stop approx. 100 mm (3.9 in) b efore the en d of str oke). 3. Next, operate the st eering, bucket, and lift ar m cylinders end of their stroke loosen air bleed pl 3 to 4 times, then sto ug (1) to bleed the air f p the engine rom the hyd again. tank. After bleeding the air, tighten plug (1) 4.
Check the hydraulic oil level and ensure tha t is correct, to 5. Increase the engine speed, and repeat step 3 to bleed t until no more bubbl es come out from plug. If the engine is run at high speed at first, o moved to the end damage the piston 6. After completing th e air bleed operation, tig hten plug (1) Tightening torque: 9.83 to 12.77 Nm (1.0 to 1.3 kgm, 7. 2 to 9.4 lbft 7. Check the hydraulic oil level and ensure tha t is correct, Refer to "CHECK OIL LEVEL IN HYDRAULIC T ANK, ADD OIL (PAGE 4-