Komatsu — WHEN REQUIRED

. MAINTENANCE SERVICE PROCEDURE way. 4 - 41 ADJUSTME 1. Install a djustment bolt (1) a nd locknu t (2) t o yoke ( 3). 2. Tighten adjustment bolt (1) until the cl earance b etween pin (6) of the te nsion pulle y (5) an d the end f ace o f the oblong hole of yoke (3 ) is 0 mm, t hen tigh ten a furth er 6 t urns Lock se curely with locknut After op eratin g for 1 hour, i f there is a gap betwee n pin (6) of tension pulley (5) a nd the oblong hol e of y oke (3), repeat t he proced ure in Step 2 to adju st again. If there is any squealing fro m the fan belt, adjust i n the same