Komatsu — EVERY 250 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE 4 - 52 CHECK ALTERNATOR BELT TENSION, ADJUS T Carr y out r (1). the inspection and adjustment work after removing cove CHECKING ould normally deflect by about 20 mm (0.79 in) when The belt sh pressed wi th the f inger (wit h a force of appr ox. 58.8 N (6 kg) at a poin t midw ay between the d rive pulle y and a lternator pulley. ADJUSTIN G bolt (1) and lock nut (2). djustment nut (3) to adjust the belt tension so that the 1. L 2. T d f 3. 4. 5. I a I i o 1. L oosen bolt (1 ) and lock 2. T urn a djustme nt nut (3) to adjus the eflect ion is a pprox. 20 mm (0.8 in ) when pressed w ith a finger orce o f appro x. 58.8 N {6 kg}. ) and bolt (1).

wear of the V-groove, and 3. 4. After a Check djusting each p , tighten l ulley for ocknut (2 damage, ) and b wear o wear o f the V -belt. Be particular ly care ful to che ck that the oove. owance for the V-belt i s not in contact with the b ottom o f the V-gr 5. I f the b elt has elongate d and the re is no more all owance for djustment, or if the bel t is cut or cracke d, replace the bel t. f the V -belt h as been r eplaced w ith a n ew part, th ere will be nitial e longati on, so ins pect and adjust it again afte r one-hour f operation.