. MAINTENANCE SERVICE PROCEDURE CHECK AIR CONDITIONER COMPRESSOR BELT TENSION, ADJUST Carry out the inspection and adjustment work after removing cover (1). CHECK WHEN CHANGING THE V-BELT Deflection when cheking: [98.1 N (10 kg)] 12.5 to 16.5 mm (0.5 to 0.7 in) Deflection when replacing: [98.1 N (10 kg)] 9 to 12.5 mm (0.355 to 0.5 in) 4 - 53 CHECKING The deflection sh when pressed wit ould be approx. 12.5 to 16.5 mm (0.5 to 0.7 in) The when h a finger force of a pprox. 98.1 N (10 kg) at a point midway betw een the air condition er compressor p ulley and drive pulley. Whe of 35 n using a belt 3 to 530 N (3 tension gauge, the te 6 to 54 kg).
nsion should be in a range The deflection sh ould be approx. 9 to 1 2.5 mm (0.355 to 0.5 in) when pressed with a fing er force of approx. 98.1 N (10 kg) at a poi nt midway between th e air conditioner compressor pulley and drive pull Whe n using a belt tension gauge, the t ension should be in a range of 530 to 745 N (54 to ADJUSTING 1. L oosen lock n 2. T urn adjustme nt nut (2) to adjust so that the belt tens ion is the pecified valu 3. A fter adjusting , tighten lock nut (1). 4. C heck each p ulley for damage, w -belt. Be particularly ear of the V -belt is not in contact with the bott om of the V-groo 5.
If the belt has elongated and there i s no more allowa nce for adjustment, or if the belt is cut or cracked, replace he belt. the V-belt ha s been replaced with a new part, there will be initial elongation, so inspect and adjust it again after ne-hour of o peration.