Komatsu — EVERY 2000 HOURS SERVICE

. MAINTENANCE SERVICE PROCEDURE REPLACE BRAKE OIL TANK BREATHER WARNING cause burns. Wait for the REPLACE ELEMENT IN AIR CONDITIONER RECIRCULATION AIR FILTER, FRESH AIR FILTER air filter, see "CLEAN ELEMENT IN AIR CONDITIONER see "CLEAN ELEMENT IN AIR CONDITIONER FRESH AIR FILTER 4 - 81 T temperature to go dow n before starting the work. When removing the oil filler cap, turn it slow ly to re lease t he internal pressure, then remove it. 1. Open the cover on top of the platform 2. Loosen bolt (1) at t he top of the cap. 3. Remove the cap a 4. Coat O-ring of the new element with g rease , then instal 5. Align the cap with i ndent or protrusion of the body, t hen ti ghten bolt (1).

Close the cover o n top of the platform on the left side of the 6. Remove both the recir culation air filter and fresh air filte r in th e same way as when clean ing, and replace them with new parts. For details of clean RECIRCULATION FIL TER (PAGE 4-54)" For details of cleaning (PAGE 4-49)". CLEAN PPC CIRCU IT STRAINER ) of the PPC circuit strainer. er case and pull out the strainer, then wash ean diesel fuel. in the strainer case, and install it with bolts lever in TILT position and lift arm control osition, and after cylinder reaches stroke osition for one minute. lever in DUMP position and lift arm control ition, and after cylinder reaches stroke end, n for one minute. 1. 2. 3. 4. 5. 6.

1. Remove 3 bolts (1 ) of the PPC circuit strain 2. Remove the strain er case and pull out the st rainer, then wash the strainer with cl Install the strainer (1). 4. Put bucket control lever in TILT position a nd lift a rm c ontrol lever in FLOAT p osition, and after c ylinde troke end, keep in that p osition for one minute. 5. Put bucket control lever in DUMP position a nd lift arm c ontrol lever in RAISE pos ition, and after cylinder re aches strok e end, keep in that positio n for one minute. 6. Bleed the air from t he hydraulic circuit. For d etails, see " BLEEDING AIR FROM PP C CIRCUIT (PAGE 4-36)".