Kubota — Kubota D-Series Engine Manual: Safety, Maintenance, and Operation Guide

21 PERIODIC SERVICE B For the air cleaner with a dust cup (optional) Remove and clean out the dust cup before it becomes half full with dust; usually once a week, or even every day if the working surroundings are dusty. Install the air cleaner dust cup with "TOP" indicated on the rear of the cup in the up position. (However, it may be installed in either direction when the cover is placed at the lower part.) FAN BELT ENGLISH B Adjusting fan belt tension To avoid personal injury: A Be sure to stop the engine and remove the key before checking the belt tension. A Be sure to reinstall the detached safety shield after maintenance or checking.

A If the dust cup is mounted incorrectly, dust or dirt does not collect in the cup, and direct attachments of the dust to the element will cause its lifetime to shorten to a great extent. 1. Stop the engine and remove the key. 2. Apply moderate thumb pressure to belt between pulleys. 3. If tension is incorrect, loosen the alternator mounting bolts and, using a lever placed between the alternator and the engine block, pull the alternator out until the deflection of the belt falls within acceptable limits. 4. Replace fan belt if it is damaged.

(1) Air cleaner body (2) Element (3) Wing bolt (4) Dust cup (5) "TOP" mark A If belt is loosen or damaged and the fan is damaged, it could result in overheats or insufficient charging. Correct or replace belt. ELECTRIC WIRING To avoid personal injury: Shorting of electric cable or wiring may cause a fire. A Check to see if electric cables and wiring are swollen, hardened or cracked. A Keep dust and water away from all power connections. Loose wiring terminal parts, make bad connections. Be sure to repair them before starting the engine. (1) Fan belt (2) Bolt and nut (A) 7 to 9 mm (0.28 to 0.35 in.) (under load of 10kgf (22.1 lbs)) Damaged wiring reduces the capacity of electrical parts.

Change or repair damaged wiring immediately. CAUTION Proper fan belt tension A deflection of between 7 to 9 mm (0.28 to 0.35 in.) when the belt is pressed in the middle of the span. CAUTION