Komatsu — PROCEDURE FOR INCREASING OR REDUCING TRACK FRAME GAUGE

. OPERATION TRANSPORTATION PROCEDURE FOR INCREASING OR REDUCING TRACK FRAME GAUGE WARNING mounting bolts (1) (front and rear: 9 install 8 of frame on the 3 - 188 Never use t he machine for op erations wi th the track fr ame retracted Never oper ate the cylinders s uddenly w hen extending or retracting the track frame gauge width. I t is dangerous if they are operated su Stop the m achine on firm leve l ground w hen extendin g or retracting the Reducing Track Gauge 1. 1. Remove center f each) on one side. 2. Swing th e upper structur e to the s ide where t he trac k frame gauge is to be reduced, se t it at 90° to track fram e (2), t hen u se the work equipmen t to jac k up the t rack frame.

3. Set block s (3) (20 to 30 cm (8 to 12 i n) wooden b locks) t owards the outsi de of track fram e (2), then use the boom cylinder to ck frame (2) will slide and om cylinder to lower the machine slowl y. The tra nd stop whe n it contacts the stopper. 4. Lower th e machin e slow ly to the ground, th removed Tighte mounting bolts ( ning torque: 152 front and 0 - 1910 5 - 195 kg 5. Follow th other sid