Komatsu — PROCEDURE FOR INCREASING OR REDUCING TRACK FRAME GAUGE

. OPERATION TRANSPORTATION be extended. 3 - 189 Increasing Track Gaug 1. Remove center fra me mounting bolts (1) (fron t + rear: eac h 4 bolts) from the fron t and rear of the track fram e on the side to 2. the track frame gauge i s to be increased, set it at 90 ° to track frame (2), then use the w ork equipment to jack up th e track fram REMARK Height (H) of the track mm (2 in). Take care n ot to raise the track frame s o much that the stopper bolt is distorte 3. Using the arm, pul l the machine to the front. ll slide. rame until it comes into contact with the The track frame wi 4. Extend the track f the stopper, then lowe bolts (1) (front + r torque. Tightening torqu 5.

Follow the same p other side. stopper, then lowe r the machine slowly to the ground. Install bolts (1) (front + r torque. ear: each 9 bolts) and tighten to specified e: 1520 - 1910 Nm (155 - 195 kgm, 1121 - 1410 lbft) rocedure to retract the track frame on the Tightening torqu (155 - 195 kgm, 1121 - 1 5.