. MAINTENANCE MAINTENANCE PROCEDURE MAINTENANCE MAINTENANCE PROCEDURE fuel or oil, then install it to ( 0.02 -0.046 kgm, 0.1 - 0.3 11. Clean the filter holder, fill the new filter cartridge with clean fuel, coat the packing surface thinly with oil, then install to the filter holder. 4 - 56 7. Remove seal (5) from transpar 8. If transparent cap (4) is damag Coat new seal (5) with clea transparent cap (4). 9. Install transparent cap (3) to n Tightening torque for transp 10.0 Nm (1.0 kgm, 7.2 lbft) Tightening torque for transp 10. Check that the drain valve (3) (4) is tightened securely. Tightening torque: 0.2 - 0.45N lbft) (4) is tightened securely.
NOTICE When adding fuel, do not remove c small holes (A) on the dirty side. After adding fuel, remove cap (B) an Always fill with clean fuel. Be caref the fuel. In particular, center portion cap (B) when adding fuel. Be careful portion on the clean side. 12. When installing, tighten until th e packing surface contacts the seal surface of the filter h older, then tighten it 3/4 of a turn. If the filter cartridge is tightene d too far, the packing will be damaged and this will lead t o leakage of fuel. If the filter cartridge is too loose, fue l will also leak from the packing, so always tighten the co When tightening with a filter wrench, be extremely careful not to dent or damage the 13.
Turn the valve (1) at the botto position (O). 14. After replacing the filter cartrid low idling for 10 minutes. Check for leakage of fuel fr tranparent cap mounting. If tightening of the filter cartridg repeat Steps 1 - 6 to remove damage or embedded foreign is found, replace it with a new c to install it.