. MAINTENANCE MAINTENANCE PROCEDURE EVERY 5000 HOURS MAINTENANCE CHANGE OIL IN HYDRAULIC TANK WARNING may cause burns. Wait for the NOTICE If the machine is equipped with a hydraulic breaker, much faster than during normal bucket operations. For details, see "MAINTENANCE INTERVAL FOR HYDRAULIC BREAKER (PAGE 4-17)" when carrying out maintenance. 4. Remove the cap of oil filler port (F) at the top of the hydraulic tank. 4 - 82 Maintenance for every 50, 250, 500 and 1000 h ours serv ice should be carri ed out at t he same t temperature to go down before starting the work.
When removing the oil filler cap, turn it slowly to r elease the i nternal pressure, the n remove it the hydra ulic oil will deteriorat Refill capacity: 248 li ters (65.52 US gal) r the socket wrench). Prepare a handle (fo 1. Swing the upper str and drain plug (A) a in the middle betwe 2. Retract the arm and put the teeth in con 3. Set the lock lever to 1. Swing the upper str ucture so that hydraulic tank drain plug (P) t the bottom of the pum p suction tube are en the left and right trac ks. 2. Retract the arm and bucket cylinders, then lo wer the b oom and tact with the ground. the LOCK position and stop the engine. 3.
Set the lock lever to the LOCK position and stop the op of the h ydraulic