MEASURING THE COMPRESSION PRESSURE 6.Measure: Compression pressure Above the maximum pressure: Inspect the cylinder head, valve surfaces, and piston crown for carbon deposits. Below the minimum pressure: Squirt a few drops of oil into the affected cyl- inder and measure again. Refer to the table below. Compression pressure (at sea level): Standard: 1,324 kPa (13.24 kg/cm 2 , 188.31 psi) Minimum: 1,150 kPa (11.5 kg/cm 2 , 163.57 psi) Maximum: 1,480 kPa (14.8 kg/cm 2 , 210.50 psi) ***************************************************** Measurement steps:
Crank over the engine with the electric starter (be sure the battery is fully charged) with the throttle wide-open until the compres- sion reading on the gauge stabilizes. When cranking the engine, ground the spark plug lead to prevent sparking. ***************************************************** 7.Install: Spark plug 3 - 25 CHK ADJ CHK ADJ Compression pressure (with oil introduced into cylinder) Reading Diagnosis Higher than without oil Worn or damaged pistons Same as without oil Defective ring(s), valves, cylinder head gasket or piston is possible. WARNING WARNING 18 Nm (1.8 m • kg, 13 ft • lb) R. T.