6.Install: Engine oil drain bolt 1 7.Fill: Crankcase (with sufficient oil to reach the specified level) Refer to “CHECKING THE ENGINE OIL LEVEL”. Oil quantity: Periodic oil change: 1.9 L (1.7 Imp qt, 2.0 US qt) With oil filter replacement: 2.0 L (1.8 Imp qt, 2.1 US qt) Total amount: 2.2 L (1.9 Imp qt, 2.3 US qt) Engine oil filler plug 9.Warm up the engine for a few minutes, then stop the engine. 10.Check: 8.Install: Engine (for engine oil leaks) Oil level Refer to “CHECKING THE ENGINE OIL LEVEL”. 11.Check: Engine oil pressure ***************************************************** Slightly loosen the oil gallery bolt 1 .
Start the engine and keep it idling until engine oil starts to seep from the oil gallery bolt. If no engine oil comes out after one minute, turn the engine off so that it will not seize. Check the engine oil passages, the oil filter cartridge and the oil pump for damage or leakage. Refer to “CRANKSHAFT AND OIL PUMP” in CHAPTER 4. 3 - 28 CHANGING THE ENGINE OIL CHK ADJ CHK ADJ R. T. 30 Nm (3.0 m • kg, 22 ft • lb)