3.Check: Coolant level The coolant level should be between the minimum level mark a and maximum level mark b . Below the minimum level mark Add the recommended coolant to the proper level. CAUTION: Adding water instead of coolant lowers the antifreeze content of the coolant. If water is used instead of coolant, check and if necessary, correct the antifreeze concentration of the coolant. Use only distilled water. However, soft water may be used if distilled water is not available. 4.Start the engine, warm it up for several min- utes, and then turn it off. 5.Check: Coolant level NOTE: Before checking the coolant level, wait a few minutes until the coolant has settled. 6.Install:
Fuel tank side panel (left) Seat Refer to “SEAT, CARRIERS, FENDERS AND FUEL TANK”. CHANGING THE COOLANT 1.Remove: Seat Fuel tank side panel (left) Engine side cover Front carrier Front fender panel Coolant reservoir cover Refer to “SEAT, CARPIERS, FENDERS AND FUEL TANK”. Left footrest board Refer to “FOOTREST BOARDS”. 3 - 32 CHECKING THE COOLANT LEVEL/ CHANGING THE COOLANT CHK ADJ CHK ADJ