Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

CHANGING THE COOLANT 2.Remove: Plastic band 1 Coolant reservoir bolts 2 Coolant reservoir cap 3 3.Disconnect: Coolant reservoir breather hose 4 4.Drain: Coolant (from the coolant reservoir) 5.Connect: Coolant reservoir breather hose 6.Install: Coolant reservoir bolts Plastic band 7.Remove: Radiator cap 1 WARNING A hot radiator is under pressure. Therefore, do not remove the radiator cap when the engine is hot. Scalding hot fluid and steam may be blown out, which could cause seri- ous injury. When the engine has cooled, open the radiator cap as follows:

Place a thick rag or a towel over the radia- tor cap and slowly turn the radiator cap counterclockwise toward the detent to allow any residual pressure to escape. When the hissing sound has stopped, turn the radiator cap counterclockwise while pressing down on it and then remove it. 8.Remove: Coolant drain bolt (water pump) 1 (along with the copper washer) 9.Drain: Coolant 3 - 33 CHK ADJ CHK ADJ