CLEANING THE SPARK ARRESTER Tap the tailpipe lightly with a soft-face ham- mer or suitable tool, then use a wire brush to remove any carbon deposits from the spark arrester portion of the tailpipe and the inner contact surfaces of the muffler. Insert the tailpipe 2 into the muffler and align the bolt holes. Insert the bolt 1 and tighten it. Start the engine and rev it up approximately twenty times while momentarily creating exhaust system back pressure by blocking the end of the muffler with a shop towel. Stop the engine and allow the exhaust pipe to cool. ***************************************************** 3 - 38 CHK ADJ CHK ADJ