Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

ADJUSTING THE REAR BRAKE/ CHECKING THE BRAKE FLUID LEVEL Adjust the select lever control cable. Refer to “ADJUSTING THE SELECT LEVER CONTROL CABLE AND SHIFT ROD”. Install the rear brake master cylinder cover. WARNING After this adjustment is performed, lift the front and rear wheels off the ground by placing a block under the engine, and spin the rear wheels to ensure there is no brake drag. If any brake drag is noticed perform the above steps again. ***************************************************** CHECKING THE BRAKE FLUID LEVEL 1.Place the machine on a level surface. NOTE: When inspecting the brake fluid level, make sure that the top of the brake fluid reservoir top is horizontal.

2.Remove: Rear brake master cylinder cover 1 3.Check: И Brake fluid level Fluid level is under “LOWER” level line 1 Fill up. И Front brake Й Rear brake CAUTION: Brake fluid may erode painted surfaces or plastic parts. Always clean up spilled fluid immediately. 3 - 41 CHK ADJ CHK ADJ Recommended brake fluid: DOT 4 É