CHECKING THE CONSTANT VELOCITY JOINT DUST BOOT 1.Check: Dust boots 1 Damage Replace. Refer to “FRONT CONSTANT VELOCITY JOINTS AND DIFFERENTIAL GEAR” in CHAPTER 7. CHECKING THE STEERING SYSTEM 1.Place the machine on a level surface. 2.Check: Steering assembly bushings Move the handlebar up and down, and/or back and forth. Excessive play Replace the steering stem bushings. 3.Check: Tie-rod ends Turn the handlebar to the left and/or right until it stops completely, then move the han- dlebar from the left to the right slightly. Tie- rod end has any vertical play Replace the tie-rod end(s). 4.Raise the front end of the machine so that there is no weight on the front wheels. 5.Check:
Ball joints and/or wheel bearings Move the wheels laterally back and forth. Excessive free play Replace the front arms (upper and lower) and/or wheel bear- ings. ADJUSTING THE TOE-IN 1.Place the machine on a level surface. 2.Measure: Toe-in Out of specification Adjust. 3 - 51 CHECKING THE CONSTANT VELOCITY JOINT DUST BOOT/CHECKING THE STEERING SYSTEM/ADJUSTING THE TOE-IN CHK ADJ CHK ADJ Toe-in: 0 ~ 10 mm (0.00 ~ 0.39 in)