Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

ADJUSTING THE TOE-IN/ ADJUSTING THE FRONT SHOCK ABSORBER ***************************************************** Adjustment steps: Mark both tie-rods ends. This reference point will be needed during adjustment. Loosen the locknuts (tie-rod end) 1 of both tie-rods. The same number of turns should be given to both the right and left tie-rods 2 until the specified toe-in is obtained. This is to keep the length of the rods the same. Tighten the rod end locknuts of both tie rods. NOTE: Adjust the rod ends so that A and B are equal.

***************************************************** ADJUSTING THE FRONT SHOCK ABSORBER WARNING Always adjust both front shock absorber spring preload to the same setting. Uneven adjustment can cause poor handling and loss of stability. 1.Adjust: Spring preload Turn the adjuster 1 to increase or decrease the spring preload. Standard position: 2 Minimum (Soft) position: 1 Maximum (Hard) position: 5 3 - 53 CHK ADJ CHK ADJ R. T. Locknut (rod end): 15 Nm (1.5 m • kg, 11 ft • lb)