CAMSHAFT AND CYLINDER HEAD 3.Measure: Cylinder head warpage Out of specification Resurface. ***************************************************** Measurement and resurfacing steps: Place a straightedge and a feeler gauge across the cylinder head. Use a feeler gauge to measure the warpage. If the warpage is out of specification, resur- face the cylinder head. Place a 400 ~ 600 grit wet sandpaper on the surface plate, and resurface the head using a figure-eight sanding pattern. NOTE: To ensure an even surface rotate the cylinder head several times. ***************************************************** INSTALLING THE CAMSHAFT AND CYLINDER HEAD 1.Install: Cylinder head Bolts (M9 :
1 ~ 6) Tighten the bolts in the proper sequence. Follow the numerical order shown in the illus- tration. Tighten the bolts in two stages. 4 - 21 ENG Cylinder head warpage: Less than 0.05 mm (0.002 in) R. T. Bolt (M6 : 7) ● R. T. R. T. 38 Nm (3.8 m • kg, 27 ft • lb) R. T. 10 Nm (1.0 m • kg, 7.2 ft • lb) NOTE: