Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

Install the decompressor cam guide plates 9 and camshaft sprocket bolts 0 . NOTE: Insert a screwdriver into the timing chain ten- sioner hole and push the timing chain guide inward. Remove the retaining wire. ***************************************************** 3.Install: Timing chain guide 4.Install: Timing chain tensioner ***************************************************** Installation steps: a.Lightly press the timing chain tensioner rod into the timing chain tensioner housing by hand. b.While pressing the timing chain tensioner rod, wind it clockwise with a thin screwdriver 1 until it stops.

c.With the screwdriver still inserted into the timing chain tensioner, install the timing chain tensioner and gasket onto the cylinder block. Then, tighten the timing chain ten- sioner bolts to the specified torque. WARNING Always use a new gasket. NOTE: The “UP” mark on the timing chain tensioner should face up. d.Remove the screwdriver, make sure that the timing chain tensioner rod releases, and tighten the cap bolt to the specified torque. ***************************************************** 5.Check: Small holes on camshaft sprocket Rotor “I” mark Out of alignment Adjust. 4 - 23 CAMSHAFT AND CYLINDER HEAD ENG R. T. Camshaft sprocket bolt: 20 Nm (2.0 m • kg, 14 ft • lb) R. T.

Timing chain tensioner bolt 10 Nm (1.0 m • kg, 7.2 ft • lb) R. T. Timing chain tensioner cap bolt 7 Nm (0.7 m • kg, 5.7 ft • lb)