Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

VALVES AND VALVE SPRINGS Install the valve into the cylinder head. Turn the valve until the valve face and valve seat are evenly polished, then clean off all of the compound. NOTE: For best lapping results, lightly tap the valve seat while rotating the valve back and forth between your hands. Apply a fine lapping compound to the valve face and repeat the above steps. NOTE: After every lapping operation be sure to clean off all of the compound from the valve face and valve seat. Apply Mechanic’s blueing dye (Dykem) to the valve face. Install the valve into the cylinder head. Press the valve through the valve guide and onto the valve seat to make a clear pattern.

Measure the valve seat width again. If the valve seat width is out of specification, reface and relap the valve seat. ***************************************************** 10.Measure: Valve spring free length a Out of specification Replace. Free length (valve spring): Intake: 32.63 mm (1.28 in) : 31.0 mm (1.22 in) Exhaust: 36.46 mm (1.44 in) : 34.6 mm (1.36 in) 4 - 29 ENG