Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

8.Measure: Valve seat width a Out of specification Reface the valve seat. Valve seat width: Intake: 0.9 ~ 1.1 mm (0.0354 ~ 0.0433 in) : 1.6 mm (0.0630 in) Exhaust: 0.9 ~ 1.1 mm (0.0354 ~ 0.0433 in) : 1.6 mm (0.0630 in) ***************************************************** Measurement steps: Apply Mechanic’s blueing dye (Dykem) b to the valve face. Install the valve into the cylinder head. Press the valve through the valve guide and onto the valve seat to make a clear pattern. Measure the valve seat width. Where the valve seat and valve face made contact, blueing will have been removed. If the valve seat is too wide, too narrow, or the seat is not centered, the valve seat must be refaced.

***************************************************** 9.Lap: Valve face Valve seat NOTE: After refacing the valve seat or replacing the valve and valve guide, the valve seat and valve face should be lapped. ***************************************************** Lapping steps: Apply a coarse lapping compound to the valve face. CAUTION: Do not let the compound enter the gap between the valve stem and the guide. Apply molybdenum disulfide oil to the valve stem. 4 - 28 VALVES AND VALVE SPRINGS ENG