REMOVING THE PISTON 1.Remove: Piston pin clips 1 Piston pin 2 Piston 3 NOTE: Put identification marks on each piston head for reference during reinstallation. Before removing each piston pin, deburr the clip groove and pin hole area. If the piston pin groove is deburred and the piston pin is still difficult to remove, use the piston pin puller 4 . CAUTION: Do not use a hammer to drive the piston pin out. 2.Remove: Piston rings NOTE: Spread the end gaps apart while at the same time lifting the piston ring over the top of the piston crown, as shown in the illustration. CHECKING THE CYLINDER AND PISTON 1.Check:
Cylinder and piston walls Vertical scratches Rebore or replace the cylinder and the piston. 2.Measure: Piston-to-cylinder clearance ***************************************************** Measurement steps: 1st step: Measure the cylinder bore “C” with a cylinder bore gauge 1 . a 50 mm (2.0 in) from the top of the cylinder 4 - 33 CYLINDER AND PISTON ENG Piston pin puller: P/N. YU-01304, 90890-01304