CYLINDER AND PISTON NOTE: Measure cylinder bore “C” in parallel to and at right angles to the cylinder matching surface. Then, find the average of the measurements. If out of specification, rebore or replace the cylinder, and replace the piston and piston rings as a set. 2nd step: Measure piston skirt diameter “P” with a micrometer. b 5.0 mm (0.20 in) from the piston bottom edge If out of specification, replace the piston and piston rings as a set. 3rd step: Find the piston-to-cylinder clearance with the following formula. Piston-to-cylinder clearance = Cylinder bore “C” – Piston skirt diameter “P” Piston-to-cylinder clearance: 0.05 ~ 0.07 mm (0.0020 ~ 0.0028 in) :
0.15 mm (0.0059 in) If out of specification, rebore or replace the cylinder, and replace the piston and piston rings as a set. ***************************************************** 4 - 34 ENG Standard Wear limit Cylinder bore “C” 100.005 ~ 100.055 mm (3.9372 ~ 3.9392 in) 100.100 mm (3.9404 in) X+Y C = 2 Piston skirt diameter “P”: Standard 99.945 ~ 99.995 mm (3.9348 ~ 3.9368 in)