CHECKING THE PISTON RING 1.Measure: Ring side clearance Use a feeler gauge. Out of specification Replace the piston and rings as a set. NOTE: Clean carbon from the piston ring grooves and rings before measuring the side clearance. 2.Position: Piston ring (in cylinder) NOTE: Insert a ring into the cylinder and push it approximately 50 mm (2.0 in) into the cylinder. Push the ring with the piston crown so that the ring will be at a right angle to the cylinder bore. a 50 mm (2.0 in) 3.Measure: Ring end gap Out of specification Replace. NOTE: You cannot measure the end gap on the expander spacer of the oil control ring. If the oil control ring rails show excessive gap, replace all three rings.
4 - 35 CYLINDER AND PISTON ENG Side clearance Standard Limit Top ring 0.04 ~ 0.08 mm (0.0016 ~ 0.0031 in) 0.13 mm (0.0051 in) 2nd ring 0.03 ~ 0.07 mm (0.0012 ~ 0.0028 in) 0.13 mm (0.0051 in) End gap Standard Limit Top ring 0.30 ~ 0.45 mm (0.0118 ~ 0.0177 in) 0.70 mm (0.0276 in) 2nd ring 0.30 ~ 0.45 mm (0.0118 ~ 0.0177 in) 0.80 mm (0.0315 in) Oil ring 0.2 ~ 0.7 mm (0.0079 ~ 0.0276 in) —