CHECKING THE PISTON PIN 1.Check: Piston pin Blue discoloration/grooves Replace, then inspect the lubrication system. 2.Measure: Piston pin-to-piston clearance ***************************************************** Measurement steps: Measure the piston pin outside diameter a . If out of specification, replace the piston pin. Outside diameter (piston pin): 21.991 ~ 22.000 mm (0.8658 ~ 0.8661 in) : 21.971 mm (0.8650 in) Measure the piston inside diameter b . Piston pin bore inside diameter: 22.004 ~ 22.015 mm (0.8663 ~ 0.8667 in) : 22.045 mm (0.8679 in) Calculate the piston pin-to-piston clearance with the following formula.
Piston pin-to-piston clearance = Bore size (piston pin) b Outside diameter (piston pin) a If out of specification, replace the piston. Piston pin-to-piston clearance: 0.004 ~ 0.024 mm (0.00016 ~ 0.00094 in) : 0.07 mm (0.003 in) ***************************************************** INSTALLING THE PISTON 1.Install: Piston rings (onto the piston) NOTE: Be sure to install the piston rings so that the manufacturer’s marks or numbers are located on the upper side of the rings. Lubricate the piston and piston rings liberally with engine oil. 4 - 36 CYLINDER AND PISTON ENG