CYLINDER AND PISTON 2.Position: Top ring 2nd ring Oil ring Offset the piston ring end gaps as shown. a Top ring end b Oil ring end (lower) c Oil ring end (upper) d 2nd ring end 3.Install: Piston 1 Piston pin 2 Piston pin clips 3 New NOTE: Apply engine oil onto the piston pin, piston ring and piston. Be sure that the arrow mark a on the piston points to the exhaust side of the engine. Before installing the piston pin clip, cover the crankcase with a clean rag to prevent the piston pin clip from falling into the crankcase. 4.Lubricate: Piston Piston rings Cylinder NOTE: Apply a liberal coating of engine oil. INSTALLING THE CYLINDER 1.Install:
Cylinder O-ring New Install the cylinder with one hand while com- pressing the piston rings with the other hand. CAUTION: Be careful not to damage the timing chain damper during installation. Pass the timing chain through the timing chain cavity. 4 - 37 ENG R. T. 42 Nm (4.2 m • kg, 30 ft • lb) R. T. 10 Nm (1.0 m • kg, 7.2 ft • lb) NOTE: