Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

RECOIL STARTER AND AC MAGNETO 2.Install: Woodruff key CDI rotor NOTE: Before installing the rotor, clean the outside of the crankshaft and the inside of the rotor. After installing the rotor, check that the rotor rotates smoothly. If not, reinstall the key and rotor. 3.Install: Dowel pins Gasket New Crankcase cover (left) NOTE: When installing the crankcase cover (left), use a long rod to hold the CDI rotor in posi- tion from the outside. This will make assem- bly easier. Be careful not to damage the oil seal. Tighten the bolts in stages, using a criss- cross pattern. 4.Install: Starter pulley 1 NOTE: Use a rotor holding tool 2 to hold the starter pulley. NOTE:

Before installing the starter pulley, do not for- get to install the O-ring. 4 - 45 ENG R. T. 10 Nm (1.0 m • kg, 7.2 ft • lb) R. T. 55 Nm (5.5 m • kg, 40 ft • lb) Rotor holding tool: P/N. YU-01235, 90890-01235