Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

REMOVING THE CLUTCH 1.Remove: Clutch housing assembly Gasket Dowel pins NOTE: Working in crisscross pattern, loosen each bolt 1/4 of a turn. Remove them after all of them are loosened. Punched portion of the nut 1 . 3.Remove: 2.Straighten: Nut 1 NOTE: Use a clutch holding tool 2 to hold the clutch carrier assembly. CHECKING THE CLUTCH 1.Check: Clutch housing 1 Heat damage/wear/damage Replace. One-way clutch bearing 2 Chafing/wear/damage Replace. NOTE: Replace the one-way clutch assembly and clutch housing as a set. The one-way clutch bearing must be installed with the flange side facing in. ***************************************************** Checking steps:

Install the one-way clutch bearing and clutch carrier assembly to the clutch housing and hold the clutch carrier assembly. When turning the clutch housing clockwise И , the clutch housing should turn freely. If not, the one-way clutch assembly is faulty. Replace it. When turning the clutch housing counter- clockwise Й , the clutch housing and crank- shaft should be engaged. If not, the one-way clutch assembly is faulty. Replace it. ***************************************************** 4 - 62 CLUTCH ENG Clutch holding tool: P/N. YM-91042, 90890-04086