MIDDLE GEAR REMOVING THE MIDDLE DRIVE SHAFT 1.Straighten: Punched portion of the nut (middle drive pin- ion gear) 2.Loosen: Nut (middle drive pinion gear) 1 NOTE: Secure the middle drive shaft in the vise with a clean rag. 3.Remove: Nut (middle drive pinion gear) Middle drive pinion gear Shim(s) REMOVING THE MIDDLE DRIVEN SHAFT 1.Remove: Universal joint ***************************************************** Removal steps: Remove the circlips 1 . Place the U-joint in a press. With a suitable diameter pipe 2 beneath the yoke 3 , press the bearing 4 into the pipe as shown. NOTE: It may be necessary to lightly tap the yoke with a punch. Repeat the steps for the opposite bearing. Remove the yoke.
NOTE: It may be necessary to lightly tap the yoke with a punch. ***************************************************** 4 - 88 ENG