REAR CONSTANT VELOCITY JOINT/FINAL DRIVE GEAR AND DRIVE SHAFT ASSEMBLING THE REAR CONSTANT VELOCITY JOINT 1.Apply: Lithium-soap base grease (into the ball joint assembly) 2.Install: Dust boots 1 Boot bands 2 , 3 New ***************************************************** Installation steps: Apply lithium-soap base grease into the dust boots. Lithium-soap base grease: 50 g (1.8 oz) per dust boot (rear wheel side) 60 g (2.3 oz) per dust boot (final gear case side) Install the dust boots. Install the dust boot bands. NOTE: The new boot bands may differ from the orig- inal ones. The dust boots should be fastened with the boot bands 3 at the grooves in the joint shaft.
***************************************************** 3.Check: Free play (thrust movement) Excessive play Replace the joint assem- bly. 7 - 22 DRIV