REMOVING AND DISASSEMBLING THE FINAL DRIVE ROLLER BEARING 1.Remove: Roller bearing (ring gear) 1 Use a suitable press tool 2 and an appropri- ate support for the main housing. 2.Remove: Roller bearing (final drive pinion gear) 1 ***************************************************** Removal steps: Heat the main housing only to 150 °C (302 °F). Remove the roller bearing outer race with an appropriately shaped punch 2 . Remove the inner race from the final drive pinion gear. NOTE: The removal of the final drive pinion gear roller bearing is difficult and seldom necessary. ***************************************************** 3.Install:
Roller bearing (final drive pinion gear) New ***************************************************** Installation steps: Heat the main housing only to 150 °C (302 °F). Install the roller bearing outer race using the proper adapter. Install the inner race onto the drive pinion gear. ***************************************************** 4.Install: Roller bearing 1 Use a suitable press tool 2 and a press to install the above components into the main housing. 7 - 23 REAR CONSTANT VELOCITY JOINT/FINAL DRIVE GEAR AND DRIVE SHAFT DRIV DRIV