Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

REAR CONSTANT VELOCITY JOINT/FINAL DRIVE GEAR AND DRIVE SHAFT POSITIONING THE FINAL DRIVE PINION GEAR AND RING GEAR When the final drive pinion gear, ring gear, final gear case and/or ring gear bearing hous- ing are replaced, be sure to adjust the posi- tions of the final drive pinion gear and ring gear using the shim(s). Final drive pinion gear shim selection 1.Select: Final drive pinion gear shim(s) 1 ***************************************************** Selection steps: To find the final drive pinion gear shim thick- ness “A”, use the following formula. Final drive pinion gear shim thickness:

a + ( c b d a = 92.5 mm b = a numeral (usually a decimal number) on the pinion gear bearing housing either added to “34” c = a numeral (usually a decimal number) on the pinion gear bearing housing either added to “55” d = a numeral (usually a decimal number) on the final drive gear case either added to “112” Example: 1) a = 92.5 2) If “98” is stamped on the pinion gear bearing housing, b = 34 + 0.98 = 34.98 3) If “48” is stamped on the pinion gear bearing housing, c = 55 + 0.48 = 55.48 4) If “03” is stamped on the final drive gear case, d = 112 + 0.03 = 112.03 5) Therefore, “A” is 0.97. “A” = 92.5 + (55.48 – 34.98) – 112.03 = 0.97 7 - 24 DRIV DRIV