6) Round off the hundredth digit and select the appropriate shim(s). In the example above, the calculated number is 0.97. The chart instructs you to round off 7 to 5 at the hundredth place. Thus, the shim thickness is 0.95 mm. Shims are supplied in the following thick- nesses. ***************************************************** Ring gear shim selection 1.Select: Ring gear shim(s) 1 ***************************************************** Selection steps: To find the ring gear shim thickness “B”, use the following formula. Ring gear shim thickness:
e f – ( g + h ) e = a numeral (usually a decimal number) on the final drive gear case either added to “50” f = a numeral (usually a decimal number) on the outside of the ring gear bearing housing and added to 1 g = a numeral (usually a decimal number) on the inside of the ring gear either added to or subtracted from 35.00 7 - 25 REAR CONSTANT VELOCITY JOINT/FINAL DRIVE GEAR AND DRIVE SHAFT DRIV DRIV Hundredths Rounded value 0, 1, 2 0 3, 4, 5, 6, 7 5 8, 9 10 Final drive pinion gear shim Thickness (mm) 0.15 0.30 0.40 0.45 0.50 0.60