REAR CONSTANT VELOCITY JOINT/FINAL DRIVE GEAR AND DRIVE SHAFT h =bearing thickness (considered constant) Example: 1) If “98” is stamped on the final drive gear case, e = 50 + 0.98 = 50.98 2) If “55” is stamped on the ring gear bear- ing housing, f = 1 + 0.55 = 1.55 3) If “–05” is stamped on the ring gear, g = 35 – 0.05 = 34.95 4) h = 14.00 5) Therefore, shim thickness “B” is 0.48. “B”= 50.98 – 1.55 – (34.95 + 14.00) = 49.43 – 48.95 = 0.48 6) Round off the hundredth digit and select the appropriate shim(s). In the example above, the calculated number is 0.48. The chart instructs you to round off 8 to 10 at the hundredth place. Thus, the shim thickness is 0.50 mm.
Shims are supplied in the following thick- nesses. ***************************************************** 7 - 26 DRIV DRIV Bearing thickness h: 14.00 mm Hundredths Rounded value 0, 1, 2 0 3, 4, 5, 6, 7 5 8, 9 10 Ring gear shim Thickness (mm) 0.25 0.30 0.35 0.40 0.45 0.50