REAR CONSTANT VELOCITY JOINT/FINAL DRIVE GEAR AND DRIVE SHAFT Thrust washer selection 1.Measure/select: Ring gear thrust clearance “C” ***************************************************** Measurement steps: Place four pieces of Plastigauge ® between the originally fitted thrust washer and the ring gear. Install the ring gear assembly and tighten the bolts to specification. T R . M8 Bolts (bearing housing): 23 Nm (2.3 m • kg, 17 ft • lb) M10 Bolts (bearing housing): 40 Nm (4.0 m • kg, 29 ft • lb) . NOTE: Do not turn the drive pinion gear and ring gear when measuring the clearance with Plasti- gauge ® . Remove the ring gear assembly. Measure the thrust clearance.
Calculate the width of the flattened Plastigauge ® 1 . If out of specification, select the correct washer. Selection steps: Select a suitable thrust washer using the fol- lowing chart. Repeat the measurement steps until the ring gear thrust clearance is within the specified limits. ***************************************************** 7 - 27 DRIV DRIV Ring gear thrust clearance: 0.1 ~ 0.2 mm (0.004 ~ 0.008 in) Thrust washer Thickness (mm) 1.2 1.3 1.4 1.5 1.6 1.7 1.8 1.9 2.0 2.1