REAR CONSTANT VELOCITY JOINT/FINAL DRIVE GEAR AND DRIVE SHAFT CHECKING THE DRIVE SHAFT 1.Check: Drive shaft (splines) 1 1 Coupling gear (splines) 2 Wear/damage Replace. 2 CHECKING THE FINAL DRIVE GEAR 1.Check: Final drive gear case 1 Ring gear bearing housing 2 Cracks/damage Replace. NOTE: When the final drive gear case and/or the ring gear bearing housing are replaced, be sure to adjust the shim of the final drive pinion gear and/or ring gear. 2.Check: Gear teeth Pitting/galling/wear Replace the drive pin- ion gear and ring gear as a set. Oil seals O-rings Damage Replace. 3.Check: Bearings Damage Replace. NOTE:
Reusing roller bearings is acceptable, but Yamaha recommends installing new ones. Do not reuse the oil seal. When the final drive pinion gear and/or ring gear are replaced, be sure to adjust the shim of the final drive pinion gear and/or ring gear. 7 - 29 DRIV