Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

REAR CONSTANT VELOCITY JOINT/FINAL DRIVE GEAR AND DRIVE SHAFT MEASUREMENT AND ADJUSTING THE FINAL GEAR LASH Final gear lash measurement 1.Secure the gear case in a vise or another supporting device. 2.Remove: Drain plug Gasket 3.Install: A bolt of the specified size 1 (into the drain plug hole) CAUTION: Finger tighten the bolt until it holds the ring gear. Otherwise, the ring gear will be dam- aged. 4.Attach: Gear lash measurement tool 1 Dial gauge 2 a Measuring point is 22 mm (0.87 in) 5.Measure: Gear lash Gently rotate the gear coupling from engage- ment to engagement . NOTE: Measure the gear lash at four positions. Rotate the shaft 90° each time.

7 - 30 DRIV DRIV Gear lash measurement tool: P/N. YM-01231, 90890-01231 Final gear lash: 0.1 ~ 0.2 mm (0.004 ~ 0.008 in)