Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

REAR CONSTANT VELOCITY JOINT/FINAL DRIVE GEAR AND DRIVE SHAFT Final gear lash adjustment 1.Remove: Bearing housing 1 Ring gear shim(s) 2 Ring gear 3 Thrust washer 4 2.Adjust: Gear lash ***************************************************** Adjustment steps: Select a suitable shim(s) and thrust washer(s) using the following chart. If increased by more than 0.2 mm (0.008 in): Reduce the thrust washer thickness by 0.2 mm (0.008 in) for every 0.2 mm of ring gear shim increase. If reduced by more than 0.2 mm (0.008 in): Increase the thrust washer thickness by 0.2 mm (0.008 in) for every 0.2 mm that the ring gear shim is decreased.

***************************************************** 7 - 31 DRIV DRIV Too little gear lash Reduce shim thick- ness. Too large gear lash Increase shim thick- ness. Ring gear shim Thickness (mm) 0.25 0.30 0.35 0.40 0.45 0.50 Thrust washer Thickness (mm) 1.2 1.3 1.4 1.5 1.6 1.7 1.8 1.9 2.0 2.1