Yamaha Grizzly 660 — Yamaha Grizzly 660 User Manual

REPLACING THE REAR BRAKE PAD NOTE: It is not necessary to disassemble the brake caliper and brake hose to replace the brake pads. 1.Measure: Brake pad wear limit a Out of specification Replace the brake pad as a set. 2.Install: Brake pads Brake pad spring NOTE: Always install new brake pads, brake pad shims, insulator and brake pad spring as a set. ***************************************************** Installation steps: Connect a suitable hose 1 tightly to the brake caliper bleed screw 2 . Put the other end of this hose into an open container. Loosen the brake caliper bleed screw and, using a finger, push the caliper piston into the brake caliper. Tighten the brake caliper bleed screw.

Install new brake pads, new insulator, new pad shims and a new brake pad spring. Install the retaining bolts and brake caliper. Brake pad holding bolt: 18 Nm (1.8 m • kg, 13 ft • lb) Brake caliper mounting bolt: 40 Nm (4.0 m • kg, 29 ft • lb) T R . . ***************************************************** 8 - 14 FRONT AND REAR BRAKES CHAS Brake pad wear limit: 1 mm (0.04 in) R. T. Brake caliper bleed screw: 6 Nm (0.6 m • kg, 4.3 ft • lb)