***************************************************** Installation steps: Connect a suitable hose 1 tightly to the brake caliper bleed screw 2 . Put the other end of this hose into an open container. Loosen the brake caliper bleed screw and, using a finger, push the caliper piston into the brake caliper. Tighten the brake caliper bleed screw. Install new brake pads, new pad shims 3 and a new brake pad spring. Install the retaining bolts and brake caliper. NOTE: The arrow mark a on the pad shim must point in the direction of the disc rotation. Brake pad holding bolt: 18 Nm (1.8 m • kg, 13 ft • lb) Brake caliper mounting bolt: 30 Nm (3.0 m • kg, 22 ft • lb) T R . .
***************************************************** 3.Check: Brake fluid level Refer to “CHECKING THE BRAKE FLUID LEVEL” in CHAPTER 3. 4.Check: Brake lever operation Soft or spongy feeling Bleed the front brake system. Refer to “BLEEDING THE HYDRAULIC BRAKE SYSTEM” in CHAPTER 3. 8 - 13 FRONT AND REAR BRAKES CHAS R. T. Brake caliper bleed screw: 6 Nm (0.6 m • kg, 4.3 ft • lb)