REMOVING THE STEERING KNUCKLE 1.Remove: Steering knuckle 1 NOTE: Use a general puller to separate the ball joint 2 and steering knuckle. CHECKING THE TIE ROD 1.Check: Tie rod free play and movement Free play Replace the tie rod end. Turns roughly Replace the tie rod end. 2.Check: Tie rod Bends/damage Replace. CHECKING THE STEERING KNUCKLE 1.Check: Steering knuckle Damage/pitting Replace. 2.Check: Front wheel bearings Bearings allow play in the wheel hubs or the wheel turns roughly Replace. Oil seals Damage Replace. ***************************************************** Replacement steps: Clean the outside of the steering knuckle. Remove the oil seals 1 . Drive out the bearings 2 .
WARNING Eye protection is recommended when using striking tools. Remove the spacer 3 . Apply lithium base grease to the bearings and oil seals. Install the spacer to the steering knuckle. 8 - 44 STEERING SYSTEM CHAS