STEERING SYSTEM Install the new bearings. NOTE: Install the outside bearing first. CAUTION: Do not strike the center race or balls of the bearing. Contact should be made only with the outer race. Install a new oil seal. NOTE: When installing the oil seals, the “seal side” of the oil seal faces out. ***************************************************** CHECKING THE BALL JOINT 1.Check: Ball joint Damage/pitting Replace the front arm. Free play Replace the front arm. Turns roughly Replace the front arm. CHECKING THE TIE ROD 1.Install: Tie rods (left and right) The tie rod which must be installed on the out side has grooves 1 . 2.Adjust: Toe-in Refer to “ADJUSTING THE TOE-IN” in CHAPTER 3.
8 - 45 CHAS R. T. R. T. 25 Nm (2.5 m • kg, 18 ft • lb) NOTE: