EB802010 TROUBLESHOOTING IF THE IGNITION SYSTEM FAILS TO OPERATE (NO SPARK OR INTERMITTENT SPARK): Procedure Check: 1.Fuse (main, ignition) 2.Battery 3.Spark plug 4.Ignition spark gap 5.Spark plug cap resistance 6.Ignition coil resistance 7.Engine stop switch 8.Main switch 9.Pickup coil resistance 10.Charging/rotor rotation direction detection coil resistance 11.Wiring connection (the entire ignition sys- tem) NOTE: Remove the following part(s) before trouble- shooting: 1)Seat 2)Fuel tank side panels 3)Front carrier 4)Front fender Dynamic spark tester: P/N. YM-34487 Ignition checker: P/N. 90890-06754 Pocket tester: P/N.
YU-03112, 90890-03112 Use the following special tool(s) for trouble- shooting. EB802011 CORRECT 3.Spark plug Standard spark plug: DPR8EA-9/NGK Check the spark plug condition. Check the spark plug type. Check the spark plug gap. Refer to “CHECKING THE SPARK PLUG” in CHAPTER 3. 9 - 10 IGNITION SYSTEM ELEC – + 1.Fuse (main, ignition) NO CONTINUITY Refer to “CHECKING THE SWITCH”. CONTINUITY Replace the fuse. Replace the fuse. 2.Battery INCORRECT Check the battery condition. ● Refer to “CHECKING THE BATTERY” in CHAPTER 3. Clean the battery terminals. ● Recharge or replace the battery. ● Clean the battery terminals. ● Recharge or replace the battery. ● Open-circuit voltage:
12.8 V or more at 20 °C (68 °F)